Но ведь фигня, верно? Звонок поступит например с 771234, куда его сувать? в asterisk? Или в город?

DED подскажи пожл-ста по циске а диалплан напишем ...почему отбой идет с cisco ?

поток не в работе!

Где ковырнуть cisco ? по потоку.. Поток рабочий!! На этом потоке рабочая система работает , так что в сам поток не тыкать..

RG-45 - мутота.

почему отбой идет с cisco ?

я ей сказал - шли ка лучше отбои ему!
Нет возможности устраивать публичные лекции по диал пирам. Это есть на cisco.com

show voice dsp ??
show voice port ??

VOIP-Gateway#show voice dsp

DSP DSP DSPWARE CURR BOOT PAK TX/RX
TYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT
==== === == ======== ======= ===== ======= === == ========= == ===== ============

Active Voice Call details


Current total analog signalling channels: 0
Current max allowed digital timeslot for voice: 36
Current active transcoding sessions: 0
Current free transcoding sessions: 0
Current active conferencing sessions: 0
Current free conferencing sessions: 0
Current number of DSP group: 1
Group 0:
Current allocated analog signalling channels: 0
Current free analog signalling channels: 0
Current allocated digital signalling channels: 30
Current free digital signalling channels: 6
Port(s) served: 0/0
Current Available MIPS: 600
SPMM DSPRM State Image D-sig D-sig A-sig A-sig Mips Voice/Xcode
Dsp Dsp allocate free allocate free Free Chan
0/0 0 UP FLEX6 6 0 0 0 100 0
0/1 1 UP FLEX6 6 0 0 0 100 0
0/2 2 UP FLEX6 6 0 0 0 100 0
1/0 3 UP FLEX6 6 0 0 0 100 0
1/1 4 UP FLEX6 6 0 0 0 100 0
1/2 5 UP FLEX6 0 6 0 0 100



VOIP-Gateway#show voice port

ISDN-VOICE Slot is 0, Sub-unit is 0, Port is 15
Type of VoicePort is ISDN-VOICE
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is disabled
Non Linear Processing is disabled
Non Linear Mute is disabled
Non Linear Threshold is -21 dB
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to -1 dB
Echo Cancellation is enabled
Echo Cancellation NLP mute is disabled
Echo Cancellation NLP threshold is -21 dB
Echo Cancel Coverage is set to 32 ms
Echo Cancel worst case ERL is set to 6 dB
Playout-delay Mode is set to adaptive
Playout-delay Nominal is set to 60 ms
Playout-delay Maximum is set to 250 ms
Playout-delay Minimum mode is set to default, value 40 ms
Playout-delay Fax is set to 300 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 10 s
Interdigit Time Out is set to 10 s
Call Disconnect Time Out is set to 60 s
Ringing Time Out is set to 180 s
Wait Release Time Out is set to 3 s
Companding Type is A-law
Region Tone is set for RU
Station name None, Station number None
Translation profile (Incoming):
Translation profile (Outgoing):


DS0 channel specific status info:
IN OUT
PORT CH SIG-TYPE OPER STATUS STATUS TIP RING
0/0:15 01 isdn-voice dorm none none
0/0:15 02 isdn-voice dorm none none
0/0:15 03 isdn-voice dorm none none
0/0:15 04 isdn-voice dorm none none
0/0:15 05 isdn-voice dorm none none
0/0:15 06 isdn-voice dorm none none
0/0:15 07 isdn-voice dorm none none
0/0:15 08 isdn-voice dorm none none
0/0:15 09 isdn-voice dorm none none
0/0:15 10 isdn-voice dorm none none
0/0:15 11 isdn-voice dorm none none
0/0:15 12 isdn-voice dorm none none
0/0:15 13 isdn-voice dorm none none
0/0:15 14 isdn-voice dorm none none
0/0:15 15 isdn-voice dorm none none
0/0:15 17 isdn-voice dorm none none
0/0:15 18 isdn-voice dorm none none
0/0:15 19 isdn-voice dorm none none
0/0:15 20 isdn-voice dorm none none
0/0:15 21 isdn-voice dorm none none
0/0:15 22 isdn-voice dorm none none
0/0:15 23 isdn-voice dorm none none
0/0:15 24 isdn-voice dorm none none
0/0:15 25 isdn-voice dorm none none
0/0:15 26 isdn-voice dorm none none
0/0:15 27 isdn-voice dorm none none
0/0:15 28 isdn-voice dorm none none
0/0:15 29 isdn-voice dorm none none
0/0:15 30 isdn-voice dorm none none
0/0:15 31 isdn-voice dorm none none

!
dial-peer voice 200 pots
destination-pattern [357][2357]....
direct-inward-dial
port 0/0:15
forward-digits all
no register e164
!

Подебажить
debug ccsip all

Кстати: вывод команды show voice dsp должен показывать в верхней части таблицу как изображено на
http://www.ciscosystems.biz/en/US/products/hw/gatecont/ps2250/products_tech_note09186a008011537d.shtml

Note: Before you issue the show voice dsp command, ensure that the DSPs are associated with the voice ports (T1/E1). Unless you do so, the output of the show voice dsp command is blank. In order to configure the ds0-group/PRI to associate the voice ports with the DSPs, refer to Implementing T1 CAS for VoIP or the "Configure Channelized E1 ISDN PRI" section of Configuring Channelized E1 and Channelized T1, respectively.

Для общего развития: читать лучшую книгу Кевина Валласа http://www.ciscopress.com/articles/article.asp?p=664150

зато;)

Где ковырнуть cisco ? по потоку.. Поток рабочий!! На этом потоке рабочая система работает , так что в сам поток не тыкать..

RG-45
Ну что рабочий поток? работает?
Удалось определится где user side, network side?

 

#show isdn status

Global ISDN Switchtype = primary-net5

ISDN Serial0/0:15 interface

        dsl 0, interface ISDN Switchtype = primary-net5

    Layer 1 Status:

        ACTIVE

    Layer 2 Status:

        TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

    Layer 3 Status:

        0 Active Layer 3 Call(s)

    Active dsl 0 CCBs = 0

    The Free Channel Mask:  0x80007FFF

    Number of L2 Discards = 0, L2 Session ID = 1

    Total Allocated ISDN CCBs = 0

правильный статус если user

#show isdn status

Global ISDN Switchtype = primary-net5

ISDN Serial1:15 interface

        ******* Network side configuration *******

        dsl 0, interface ISDN Switchtype = primary-net5

    Layer 1 Status:

        ACTIVE

    Layer 2 Status:

        TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED

    Layer 3 Status:

        0 Active Layer 3 Call(s)

    Active dsl 0 CCBs = 0

    The Free Channel Mask:  0x80007FFF

    Number of L2 Discards = 0, L2 Session ID = 2

    Total Allocated ISDN CCBs = 0

если network.

Влез полазил по циски, дабы друг у нас общий, в общем запустил исход с циски

подправил
voice-port 0/0:15
bearer-cap 3100Hz

interface Serial0/0:15
isdn protocol-emulate network

dial-peer voice 201 voip
description ALL from SIP to E1
preference 1
voice-class codec 1
session protocol sipv2
incoming called-number 7.....$
dtmf-relay rtp-nte
no vad
!
dial-peer voice 200 pots
description ALL-TO-E1
preference 1
destination-pattern 7.....$
no digit-strip
port 0/0:15
!


Тока я не понял при статусах потока, странно оно как-то

это если USER

VOIP-Gateway#show isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial0/0:15 interface
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = TEI_ASSIGNED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0xFFFF7FFF
Number of L2 Discards = 0, L2 Session ID = 122
Total Allocated ISDN CCBs = 0
VOIP-Gateway#sh


Это если network
VOIP-Gateway#show isdn status
Global ISDN Switchtype = primary-net5
ISDN Serial0/0:15 interface
******* Network side configuration *******
dsl 0, interface ISDN Switchtype = primary-net5
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 0, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
Layer 3 Status:
0 Active Layer 3 Call(s)
Active dsl 0 CCBs = 0
The Free Channel Mask: 0xFFFF7FFF
Number of L2 Discards = 0, L2 Session ID = 11
Total Allocated ISDN CCBs = 0


Честно от статусов от ded, я разницы не заметил, ну только если сешион ид другой, ну это и понятно. Можно для моего развития маааленький ликбез, что я глазами прохлопал :).