Re: Patch для текущего chan_h323
Да забыл. Верно для Cisco ata186, AddPac 1100F больше нигде не проверял:))
extension.conf
[Term]
exten => _7.,1,Dial(H323/${EXTEN}@x.x.x.x)
exten => _7.,2,HangUp
h323.conf
; The NuFone Network's
; Open H.323 driver configuration
;
[general]
port = 1720
bindaddr = 0.0.0.0
tos=lowdelay
;
; You may specify a global default AMA flag for iaxtel calls. It must be
; one of 'default', 'omit', 'billing', or 'documentation'. These flags
; are used in the generation of call detail records.
;
;amaflags = default
;
; You may specify a default account for Call Detail Records in addition
; to specifying on a per-user basis
;
;accountcode=lss0101
;
; You can fine tune codecs here using "allow" and "disallow" clauses
; with specific codecs. Use "all" to represent all formats.
;
disallow=all
;allow=alaw ; turns on all installed codecs
;allow=g723.1 ; Hm... Proprietary, don't use it...
;allow=gsm ; Always allow GSM, it's cool :)
allow=g729
;
; User-Input Mode (DTMF)
;
; valid entries are: rfc2833, inband
; default is rfc2833
;dtmfmode=inband
;
; Set the gatekeeper
; DISCOVER - Find the Gk address using multicast
; DISABLE - Disable the use of a GK
; <IP address> or <Host name> - The acutal IP address or hostname of your GK
gatekeeper = DISABLE
;
;
; Tell Asterisk whether or not to accept Gatekeeper
; routed calls or not. Normally this should always
; be set to yes, unless you want to have finer control
; over which users are allowed access to Asterisk.
; Default: YES
;
AllowGKRouted = yes
;
; Default context gets used in siutations where you are using
; the GK routed model or no type=user was found. This gives you
; the ability to either play an invalid message or to simply not
; use user authentication at all.
;
context=Maykop
; H.323 Alias definitions
;
; Type 'h323' will register aliases to the endpoint
; and Gatekeeper, if there is one.
;
; Example: if someone calls time@your.asterisk.box.com
; Asterisk will send the call to the extension 'time'
; in the context default
;
; [default]
; exten => time,1,Answer
; exten => time,2,Playback,current-time
;
; Keyword's 'prefix' and 'e164' are only make sense when
; used with a gatekeeper. You can specify either a prefix
; or E.164 this endpoint is responsible for terminating.
;
; Example: The H.323 alias 'det-gw' will tell the gatekeeper
; to route any call with the prefix 1248 to this alias. Keyword
; e164 is used when you want to specifiy a full telephone
; number. So a call to the number 18102341212 would be
; routed to the H.323 alias 'time'.
;
;[time]
;type=h323
;e164=18102341212
;context=default
;
;[det-gw]
;type=h323
;prefix=1248,1313
;context=detroit
;
;
; Inbound H.323 calls from BillyBob would land in the incoming
; context with a maximum of 4 concurrent incoming calls
;
;
; Note: If keyword 'incominglimit' are omitted Asterisk will not
; enforce any maximum number of concurrent calls.
;
|
